Quick Start Manual

Router Setup Manual
1-2 Connecting the Router to the Internet
v2.0, May 2007
The Front of the Router
You can use the status lights on the front of the router to verify various conditions.
Figure 1-1
Table 1-1.
Status Light
Activity Description
1. Power
On
Blink
Off
Power is supplied to the router.
The firmware is corrupt, and the router is in rescue mode running
TFTP server. You can use TFTP client to upload valid firmware.
Power is not supplied to the router.
2. Test
On
Blink
Off
The system is initializing.
Firmware is upgrading or restoring to factory default settings
.
The system is ready and running.
3. Wireless
On
Off
Indicates that the wireless router radio is enabled.
The wireless router radio is disabled.
4. Internet
On (amber)
On (green)
Blink
The Ethernet cable is connected but the router has not gotten an
Internet address.
The router has an Internet address.
Data is being communicated through the Internet port.
5. LAN (Local Area
Network) Lights
1-4
On (green)
Blink (green)
On (amber)
Blink (amber)
Off
The local port is connected to a 100 Mbps device.
Data is being transmitted at 100 Mbps.
The local port has detected a link with a 10 Mbps device.
Data is being transmitted at 10 Mbps.
No link is detected on this port.
5
1
2
3
4