User's Manual
Table Of Contents
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Overview of Wireless USB Print Server Setup
- Verify Printer and Network Readiness
- Understanding WGPS606 Wireless Security Options
- Observe these Precautions
- Set Up the Print Server
- Now, Set Up a PC
- Troubleshooting Tips
- Two Ways to Log In to the WGPS606
- Using the IP Settings Options
- Understanding the Basic Wireless Settings
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Glossary
Troubleshooting 6-1
Draft 1, 01 Feb 05
Chapter 6
Troubleshooting
This chapter provides information about troubleshooting your NETGEAR WGPS606 54 Mbps
Wireless USB Print Server with 4-Port Switch WGPS606. After each problem description,
instructions are given to help you diagnose and solve the problem. For the common problems
listed, go to the section indicated.
• Is the WGPS606 on?
• Have I connected the wireless USB print server correctly?
Go to “Basic Installation and Configuration” on page 3-1.
• I cannot remember the wireless USB print server’s configuration password.
Go to “Rebooting and Resetting Factory Default Options” on page 4-4.
This chapter gives information about troubleshooting your NETGEAR WGPS606 54 Mbps
Wireless USB Print Server with 4-Port Switch WGPS606. After each problem description,
instructions are provided to help you diagnose and solve the problem. For the common problems
listed, go to the section indicated.
• Is the wireless USB print server on and is the Status light lit?
Go to “Bottom Label Description” on page 2-4.
• Have I connected the wireless USB print server correctly?
Go to “Set Up the Print Server” on page 3-4.
• I can’t access the wireless USB print server from my computer.
Go to “Now, Set Up a PC” on page 3-5
Basic Functioning
If you have trouble setting up your WGPS606, check the tips below.
Note: For up-to-date WGPS606 installation details and troubleshooting guidance visit
http://kbserver.netgear.com/products/WG602v3.asp.