User's Manual
Table Of Contents
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Overview of Wireless USB Print Server Setup
- Verify Printer and Network Readiness
- Understanding WGPS606 Wireless Security Options
- Observe these Precautions
- Set Up the Print Server
- Now, Set Up a PC
- Troubleshooting Tips
- Two Ways to Log In to the WGPS606
- Using the IP Settings Options
- Understanding the Basic Wireless Settings
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Glossary
Management 4-1
Draft 1, 01 Feb 05
Chapter 4
Management
This chapter describes how to use the management features of your NETGEAR WGPS606 54
Mbps Wireless USB Print Server with 4-Port Switch WGPS606. These features can be found
under the Management heading in the main menu of the browser interface.
Viewing General Information
The Information summarizes of the current WGPS606 configuration settings. From the main menu
of the browser interface, click Information to view the system status screen, shown below.
Figure 4-1: Wireless USB Print Server Status screen
This screen shows the following parameters: