User's Manual
Table Of Contents
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Overview of Wireless USB Print Server Setup
- Verify Printer and Network Readiness
- Understanding WGPS606 Wireless Security Options
- Observe these Precautions
- Set Up the Print Server
- Now, Set Up a PC
- Troubleshooting Tips
- Two Ways to Log In to the WGPS606
- Using the IP Settings Options
- Understanding the Basic Wireless Settings
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Glossary
Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch
Introduction 2-5
Draft 1, 01 Feb 05
The following table explains bottom label indicators:
ITEM DESCRIPTION
Power
Off
On Green
On Amber
Power Indicator
No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 6, “Troubleshooting.”
Power is on and it has successfully completed its power on self test diagnostic.
Power is on and it is performing its power on self test diagnostic.
Switch Ethernet LAN Link Activity Indicator
Off
Green On
Indicates no Ethernet link detected.
100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n 10 Mbps Ethernet link detected, no activity.
Amber Blink Indicates data traffic on the 10Mbps Ethernet LAN.
Wireless Wireless LAN Link Activity Indicator
Off
Green On
Indicates no wireless link detected.
Wireless link enabled, no activity.
Green Blink Wireless link activity.