User's Manual
Table Of Contents
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- CE Declaration of Conformity
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Observing Placement and Range Guidelines
- Default Factory Settings
- Understanding WG602 v2 Wireless Security Options
- Installing the 54 Mbps Wireless Access Point WG602 v2
- Two Ways to Log In to the WG602 v2
- Using the Basic IP Settings Options
- Understanding the Basic Wireless Settings
- Understanding Wireless Security Options
- How to Configure WEP Wireless Security
- How to Configure WPA-PSK Wireless Security
- How to Restrict Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- Troubleshooting
- No lights are lit on the access point.
- The Ethernet LAN light is not lit.
- The Wireless LAN activity light is not lit.
- I cannot configure the wireless access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Troubleshooting
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Network, Routing, Firewall, and Cabling Basics
- Appendix D Preparing Your PCs for Network Access
- Glossary
- Index
User’s Guide for the WG602 54 Mbps Wireless Access Point
Specifications A-1
Appendix A
Specifications
This appendix provides the 54 Mbps Wireless Access Point WG602 v2 technical specifications.
Specifications for the WG602 v2
Parameter 54 Mbps Wireless Access Point WG602 v2
Radio Data Rates 1, 2, 5.5, 6, 9, 12, 18, 24, 36, 48, and 54 Mbps Auto Rate Sensing
Frequency 2.4-2.5Ghz
Data Encoding: Direct Sequence Spread Spectrum (DSSS)
Wireless Security: WEP and WPA-PSK
Maximum Computers Per
Wireless Network:
Limited by the amount of wireless network traffic generated by each node.
Typically 32 nodes.
Network Management Web-based configuration and status monitoring
Status LEDs Power/Ethernet LAN/Wireless LAN
Dimensions: 28 x 175 x 118 mm (1.1 x 6.89 x 4.65 in.)
Power Adapter 12Vdc, 1.2A
Weight 845 g (29.7 oz)
Electromagnetic
Compliance
FCC Part 15 Class B and Class E, CE
Environmental
Specifications
Operating temperature: 0 to 50° C
Operating humidity: 5-95%, non-condensing