User's Manual
Table Of Contents
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- CE Declaration of Conformity
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Observing Placement and Range Guidelines
- Default Factory Settings
- Understanding WG602 v2 Wireless Security Options
- Installing the 54 Mbps Wireless Access Point WG602 v2
- Two Ways to Log In to the WG602 v2
- Using the Basic IP Settings Options
- Understanding the Basic Wireless Settings
- Understanding Wireless Security Options
- How to Configure WEP Wireless Security
- How to Configure WPA-PSK Wireless Security
- How to Restrict Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- Troubleshooting
- No lights are lit on the access point.
- The Ethernet LAN light is not lit.
- The Wireless LAN activity light is not lit.
- I cannot configure the wireless access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Troubleshooting
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Network, Routing, Firewall, and Cabling Basics
- Appendix D Preparing Your PCs for Network Access
- Glossary
- Index
User’s Guide for the WG602 54 Mbps Wireless Access Point
3-3 Basic Installation and Configuration
Default Factory Settings
When you first receive your WG602 v2, the default factory settings will be set as shown below.
You can restore these defaults with the Factory Default Restore switch on the rear panel — see
“WG602 v2 Wireless Access Point Rear Panel” on page 2-7.
FEATURE FACTORY DEFAULT SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Access Point Name NETGEARxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP DHCP client
IP Configuration
if DHCP server is unavailable
IP Address: 192.168.0.227
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Primary DNS Server: blank
Secondary DNS Server: blank
Wireless Network Name (SSID) NETGEAR
Broadcast Network Name Enabled
802.11g/b
Radio Frequency Channel
6
WEP Disabled
Authentication Type Open System