Installation Guide
Table Of Contents
- Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
- Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Configuration
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
2-8 Basic Setup
For Windows 2000 & 98/Me Users Installing a WG511
Install the WG511 driver and configuration
utility software.
Note: Windows 2000, may require you to be
logged on with administrator rights.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG511
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the steps in the Install Shield
Wizard, and click Finish when done to
restart your computer.
WG511 Resource CD
InstallShield Wizard