Installation Guide
Table Of Contents
- Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
- Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Configuration
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
2-4 Basic Setup
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WG511
Install the WG511 driver and configuration
utility software.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG511
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the Install Shield Wizard steps,
and click Finish when done to restart
your computer.
WG511 Resource CD
Install Shield Wizard
Note: If a Windows XP Certification warning appears,
click Continue Anyway to proceed.