User Guide

Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
Basic Setup 2-9
Install the NETGEAR 108 Mbps Wireless
PCI Adapter WG311T.
a. Shut down the PC and remove the power
cord. Insert the WG311T Wireless PCI
Adapter into an available PCI slot.
b. Reconnect the power cord and reboot the
computer. After a short delay, the Found
New Hardware Wizard displays.
c. You will be prompted to choose the
country where you are located. Select
your location from the list.
d. Click Next and follow the prompts to
proceed. After the installation
completes, click Finish to close the
wizard.
You should see the WG311T system tray
icon on the lower right portion of the
Windows task bar.
Add New Hardware Wizard
Note: If Windows displays a Digital Signature Not
Found warning, click Yes to continue.
WG311T System Tray Icon