User's Manual
Table Of Contents
- User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG121
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG121
Basic Setup 3-5
Install the NETGEAR 54 Mbps Wireless
USB 2.0 Adapter WG121.
a. Locate an available USB port on your
PC. Connect the USB cable to the
WG121 and insert the other end of the
cable into the USB slot on your PC.
After a short delay, the Found New
Hardware Wizard displays.
Note: Click Continue Anyway if you
are prompted with a Windows XP Logo
testing message.
b. Next you will be prompted to enable the
NETGEAR Smart Wireless Settings
Utility configuration utility.
Click Yes to accept this option.
If you choose No, you must read the
Windows XP documentation for an
explanation of how to use the Windows
XP wireless network configuration
utility
c. Click Finish when done, and if
prompted restart your computer.
You will see the WG121 system tray
icon on the lower right portion of the
Windows task bar.
Add New Hardware Wizard
Enable NETGEAR Utility Configuration
WG121 System Tray Icon