User's Manual
Table Of Contents
- User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 5 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- General Questions
- Why do I see no more than 54 Mbps on the Configuration Utility status line?
- The WG111T Smart Configuration Utility keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111T card has received a valid IP address from the Wireless Router/AP
- How to use XP’s own Wireless configuration utility that comes with Windows XP
- I cannot connect to the AP that I want from the Networks browser list
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- General Questions
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
Index 1
Numerics
802.11b 1
A
ad-hoc mode 2
B
BSSID 2
E
ESSID 2
F
features 1
I
infrastructure mode 2
IP networking
for Windows
1, 6
L
LEDs
description
13
O
Open System authentication 4
S
Shared Key authentication 4
SSID
3, 4, 2
T
TCP/IP properties
verifying for Windows
5
troubleshooting
1
W
WEP 3, 7, 8
Wi-Fi
1, 4
Wi-Fi Protected Access (WPA)
10
Windows, configuring for IP routing
1, 6
winipcfg utility
5
Wired Equivalent Privacy. See WEP
Wireless Ethernet
1
wireless network name
3
WPA
10
Index