User's Manual
Table Of Contents
- User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 5 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- General Questions
- Why do I see no more than 54 Mbps on the Configuration Utility status line?
- The WG111T Smart Configuration Utility keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111T card has received a valid IP address from the Wireless Router/AP
- How to use XP’s own Wireless configuration utility that comes with Windows XP
- I cannot connect to the AP that I want from the Networks browser list
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- General Questions
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
3-12 Basic Setup
202-10056-01
Verify wireless connectivity to your network.
a. Verify that the status monitor information at the bottom of the utility matches your
wireless network.
b. Check the color of the WG111T icon in the Windows system tray: green or yellow
indicates a working connection; red indicates no connection.
c. Check the WG111T LED: blinking means attempting to connect; solid indicates a good
connection; off means the WG111T is not plugged in.
d. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see
Chapter 5, “Troubleshooting” .