User's Manual
Table Of Contents
- User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 5 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- General Questions
- Why do I see no more than 54 Mbps on the Configuration Utility status line?
- The WG111T Smart Configuration Utility keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111T card has received a valid IP address from the Wireless Router/AP
- How to use XP’s own Wireless configuration utility that comes with Windows XP
- I cannot connect to the AP that I want from the Networks browser list
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- General Questions
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
3-10 Basic Setup
202-10056-01
Install the NETGEAR 108 Mbps Wireless
USB 2.0 Adapter WG111T.
a. Locate an available USB port on your
PC. Connect the USB cable to the
WG111T and insert the other end of the
cable into the USB slot on your PC.
b. After a short delay, the Found New
Hardware Wizard displays. The first
time that you install the WG111T on a
computer, the wizard will install the
bootloader device. Follow the
installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
c. After the bootloader device is installed,
the Found New Hardware Wizard will
display again and install the WG111T.
Follow the installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
d. Click Finish when done, and if
prompted restart your computer.
a. You will see the WG111T system tray
icon on the lower right portion of the
Windows task bar.
Found New Hardware Wizard
Note: If your computer does not have a USB v2.0
port but rather a USB v1.1 type port, the WG111T
will be limited to the maximum speed of the USB
v1.1 port. USB v1.1 port maximum speed is 14
Mbps whereas the maximum speed of a USB v2.0
port is 480 Mbps.
WG111T System Tray Icon