User's Manual
Table Of Contents
- User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 5 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- General Questions
- Why do I see no more than 54 Mbps on the Configuration Utility status line?
- The WG111T Smart Configuration Utility keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111T card has received a valid IP address from the Wireless Router/AP
- How to use XP’s own Wireless configuration utility that comes with Windows XP
- I cannot connect to the AP that I want from the Networks browser list
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- General Questions
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
Basic Setup 3-9
202-10056-01
For Windows 2000 Users Installing a WG111T
Install the WG111T driver and configuration
utility software.
Note: Windows 2000 may require you to be
logged on with administrator rights.
a. Power on your PC, let the operating
system boot up completely, and log in as
needed.
b. Insert the Resource CD for the WG111T
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click Install Driver and Utility.
Follow the InstallShield Wizard steps.
You will be prompted to choose the
country you are located in. Select your
location from the list.
d. Click Finish when done, and if
prompted restart your computer.
WG111T Resource CD
Note: If this screen fails to load automatically,
browse to the CD and double-click on
autorun.exe.
InstallShield Wizard
Note: If a Windows 2000 Digital Signature
warning appears, click Yes to proceed.