User's Manual
Table Of Contents
- User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Setup
- Chapter 4 Configuration
- Chapter 5 Troubleshooting
- Basic Tips
- Frequently Asked Questions
- General Questions
- Why do I see no more than 54 Mbps on the Configuration Utility status line?
- The WG111T Smart Configuration Utility keeps asking me to save my settings
- Ad Hoc mode is not working correctly
- How to know if the WG111T card has received a valid IP address from the Wireless Router/AP
- How to use XP’s own Wireless configuration utility that comes with Windows XP
- I cannot connect to the AP that I want from the Networks browser list
- New Hardware Wizard appears after installation has completed
- How to get a PDF copy of the Manual
- General Questions
- Appendix A Technical Specifications
- Appendix B Wireless Networking Basics
- Appendix C Preparing Your PCs for Network Access
- Glossary
- Index
User Manual for the NETGEAR 108 Mbps Wireless USB 2.0 Adapter WG111T
2-4 Introduction
202-10056-01
Connect to the
Internet over my
wireless
network.
1. Activate my
wireless link and
verify my network
connection.
2. Open an Internet
browser such as
Internet Explorer
or Netscape
Navigator.
1. An active Internet
connection like those from
cable or DSL service
providers.
2. A wireless network
connected to the cable or
DSL Internet service
through a cable/DSL
router as illustrated in
“Connecting to an Access
Point in Infrastructure
Mode” on page 4-2
.
3. TCP/IP Internet
networking software
installed and configured
on my PC according to the
requirements of the
Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
To configure your WG111T in
Infrastructure Mode, see
“Basic
Installation Instructions” on
page 3-4
, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see
“Preparing Your
Computers for TCP/IP
Networking” on page C-1
or refer
to the PC Networking Tutorial on
the NETGEAR 108 Mbps
Wireless USB 2.0 Adapter
WG111T Resource CD and the
Help information provided in the
Windows system you are using.
.
Table 2-1. A Road Map for How to Get There From Here
If I Want To? What Do I Do? What’s Needed? How Do I?