User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Index 1
Numerics
802.11b B-1
A
ad-hoc mode B-2
Auto MDI/MDI-X C-2
Auto Uplink 2-4, C-2
B
Basic Wireless Connectivity 3-18
Basic Wireless Settings 3-9, 3-12, 3-14
BSSID B-2
C
Carrier Sense Multiple Access with Collision
Avoidance 5-2
Carrier Sense Multiple Access with Collision
Detection 5-2
Cat5 cable C-2
configuration
erasing 4-7
restore 4-6
Country Domain 3-12
crossover cable 2-4, C-2
CSMA/CA 5-2
CSMA/CD 5-2
E
ESSID 3-18, B-2
Ethernet 2-3
F
factory settings, restoring 4-7
features 2-2
G
General 4-3
I
infrastructure mode B-2
IP Settings 3-24
L
Log In to the ME103 3-11
Logout 3-7
M
MDI/MDI-X C-2
MDI/MDI-X wiring C-4
O
Open System authentication B-2
P
Passphrase 3-15, 3-20
Placement 3-1
R
Range 3-1
range 3-1
restore configuration 4-6
restore factory settings 4-7
Restrict Wireless Access by MAC Address 3-19
RTS Threshold 5-1, 5-2, 5-3
S
Saving the Configuration File 4-7
Shared Key authentication B-3
SNMP 2-2
SSID 3-12, 3-18, 4-3, B-2
T
troubleshooting 6-1
Index