User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
A-2 Specifications
October 2004
802.11b and g
Typical Transmit Power
Typical Receive Sensitivity
802.11b mode 1 to 11Mbps: + 19 dBm*
802.11g mode, 6 to 24 Mbps: +18 dBm*
802.11g mode, 36/48/54 Mbps: +17/16/15 dBm*
802.11b mode at
1/2/5.5/11Mbps: -95/-93/-91/-89 dBm
802.11g mode at
6/9/12/18/24/36/48/54 Mbps: -91/-90/-87/-84/-81/-77/-75 dBm
Note: Maximum transmit power varies based on country or region selection
to ensure local regulatory compliance.
Antenna: One (1) external 5 dBi 2.4 GHz detachable antenna
802.11 Security 40-bits (also called 64-bits), 128-bits WEP data encryption, and WPA
Parameter NETGEAR WG102 ProSafe 802.11g Wireless Access Point