User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Advanced Configuration 5-1
October 2004
Chapter 5
Advanced Configuration
This chapter describes how to configure the advanced features of your NETGEAR WG102
ProSafe 802.11g Wireless Access Point:
• Hotspot Settings: Set up advanced wireless LAN parameters.
• Wireless Settings: Set up advanced wireless LAN parameters.
• Access Point Settings: Enable wireless bridging and repeating.
These features can be found under the Advanced heading in the main menu.
Hotspot Settings
If you want the AP to capture and re-direct all HTTP (TCP, port 80) requests, use this feature. For
example, a hotel might want all wireless connections to go to its server to start a billing
transaction.
Figure 5-1: Hotspot Settings screen
Enter the URL of the Web server where you wish to redirect HTTP requests.