User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
4-4 Management
October 2004
Statistics
The Information - Statistics screen provides various LAN and WLAN statistics.
Figure 4-3: Wireless Access Point Status screen
Table 4-1. Statistics Fields
Field Description
Wired Ethernet Received/Transmitted
Packets The number of packets sent since the WG102 was restarted.
Bytes
The number of bytes sent since the WG102 was restarted.
Wireless
Received/Transmitted
Unicast Packets The Unicast packets sent since the WG102 was restarted.
Broadcast Packets The Broadcast packets sent since the WG102 was restarted.
Multicast Packets The Multicast packets sent since the WG102 was restarted.
Total Packets The Wireless packets sent since the WG102 was restarted.
Total Bytes The Wireless bytes sent since the WG102 was restarted.
Refresh button
Click the Refresh button to update the statistics on this screen.