User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Management 4-1
October 2004
Chapter 4
Management
This chapter describes how to use the management features of your NETGEAR WG102 ProSafe
802.11g Wireless Access Point. These features can be found by clicking on the Maintenance
heading in the Main Menu of the browser interface.
Using Syslog and Activity Log Information
The Information contains the activity log link you can use for setting up a syslog server and
viewing activity log information. From the main menu of the browser interface, under the
Information heading, click the Station List link to view the list, shown below.
Figure 4-1: Syslog and Activity Log information