User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
3-13 Basic Installation and Configuration
October 2004
– Using the same SSID is essential. Devices with different SSIDs are unable to
communicate with each other. However, some access points allow connections from
wireless stations which have their SSID set to “any” or whose SSID is blank (null).
– A group of wireless stations and multiple access points, all using the same ID (ESSID),
form an Extended Service Set (ESS).
– Different access points within an ESS can use different channels. To reduce interference, it
is recommended that adjacent access points should use different channels.
– As wireless stations physically move through the area covered by an ESS, they will
automatically change to the access point which has the least interference or best
performance. This capability is called roaming.
Note: The AutoCell feature enhances the roaming, interference, and channel selection of
an extended wireless network.
• Broadcast Wireless Network Name (SSID). This field lets you turn off the SSID broadcast.
If you turn off the SSID broadcast, only stations that know the SSID will connect. Disabling
SSID broadcast somewhat hampers the wireless network ‘discovery’ feature of some products.
The default is to enable SSID broadcast.
• Operating Mode. Select the desired wireless operating mode. The options are:
– Auto (11g/b) – Both 802.11g and 802.11b wireless stations can be used. This is the default.
– 11g Only - Only 802.11g wireless stations can be used. This is required for 108 Mbps data
rate operation.
– 11b Only - All 802.11b wireless stations can be used. 802.11g wireless stations can still be
used if they can operate in 802.11b mode.
• Channel. This field identifies which operating frequency will be used. It should not be
necessary to change the wireless channel unless you notice interference problems or setting up
the WG102 near another access point. See “Wireless Channels” on page B-7 for more
information on wireless channels.
– Access points use a fixed channel. You can select the channel used. This allows you to
choose a channel which provides the least interference and best performance. In the USA
and Canada, 11 channels are available.
Note: Channel 6 is required for 108 Mbps data rate.
– If using multiple access points, it is better if adjacent access points use different channels
to reduce interference. The recommended channel spacing between adjacent access points
is 5 channels (for example, use channels 1 and 6, or 6 and 11).