User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- FCC Statement
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Europe - EU Declaration of Conformity
- Requirements For Operation in the European Community
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WG102 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Index
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
Basic Installation and Configuration 3-6
October 2004
2CONFIGURE LAN AND WIRELESS ACCESS
a. Configure the WG102 Ethernet port for LAN access.
• Connect to the WG102 by opening your browser and entering http://192.168.0.229 in
the address field. A login window like the one shown below opens:
Figure 3-2: Login window
• When prompted, enter admin for the user name and password for the password, both
in lower case letters.
NEED PRODUCT PHOTO
OR ILLUSTRATION