Quick Reference Guide

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
5-10 Advanced Configuration
November 2005
How to Configure a WG102 as a Point-to-Point Bridge
Figure 5-6: Point-to-Point Bridge
1.
Configure the WG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
2. Configure the WG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have
AP1’s MAC address in its Remote MAC Address field.
3. Configure and verify the following parameters for both access points:
• Verify that the LAN network configuration of the WG102 Access Points both are
configured to operate in the same LAN network address range as the LAN devices
• Both use the same ESSID, Channel, authentication mode, if any, and security settings if
security is in use.
4. Verify connectivity across the LAN 1 and LAN 2.
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.