Manualshelf

Reference Manual

ManualsBrandsNetgear ManualsWirelessNetgear WC9500
919293949596979899100
Installation and Configuration Overview
91
ProSAFE Wireless Controller WC9500
Deploy the Wireless Controller
After you follow the steps in Roadmap for Initial Configuration on page 87 and Roadmap for
Configuring Management of Your Wireless Network on page 88, you are ready to deploy the
wireless controller in your network.
To deploy the wireless controller:
1. Disconnect the wireless controller from the computer that you used for configuration.
2. (Optional) Reconfigure the computer back to its original
TCP/IP settings.
3. Place the wireless controller where you intend to deploy it.
4. Connect an Ethernet cable from the wireless controller to a switch or router on your wired
network.
5. Connect the power cord to the wireless controller and plug the power cord into a power
outlet.
The Power
, Status, and Ethernet LEDs light. If any of these do not light, see Troubleshoot
Basic Functioning on page 338.