Reference Manual

Monitor the Wireless Network and Its Components
307
ProSAFE Wireless Controller WC9500
2. Enter your user name and password.
If you did not yet personalize your user name and password, enter admin for the user
name and password for the password, both in lowercase letters.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
screen.
4. Select Monitor > Controller > Summary.
The following table describes the fields of the Network Status, Wireless Clients, Most
Active APs, Most Active Clients and Most Active SSIDs tables of the screen. The
Controller Info section is self-explanatory.
Note: If you configure redundant controllers, the screen also displays
information about the status of the redundancy configuration. This
information is self-explanatory.
Item Description
Network Status
Total Up The total number of managed devices that are running correctly.
Down The total number of managed devices that cannot be pinged.
Alarms Critical The wireless controller can ping these managed devices, but either cannot log in or
detected that these devices are dif
ferent from the ones that were configured.
Major The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
W
ireless Clients
Open The number of wireless clients that are connected to managed access points using
security profiles configured with open mode.
WEP The number of wireless clients that are connected to managed access points using
security profiles configured with WEP
.