Quick Reference Guide

Configure the System and Network Settings and Register the Licenses
52
ProSAFE Wireless Controller WC9500
2. Click Add.
The Add DHCP Server pop-up screen displays:
3. Configure the settings as described in the following table:
Setting Description
Enabled Select this check box to enable the DHCP server.
When the check box is cleared, the DHCP server is disabled.
Use VLAN Interface Select this check box to allow the DHCP server to function with multiple VLANs.
VLAN Enter the DHCP server VLAN ID.
The range is between 1 and 4094. The DHCP server services this VLAN.
IP Network Enter the IP address for the wireless controller in the VLAN that you have
specified in the VLAN field.
If you have not selected the Use VLAN Interface check box, the IP address of
the wireless controller’
s management VLAN is used.
Subnet Mask Enter the subnet mask that is assigned to the wireless clients by the DHCP
server.
Default Gateway Enter the IP address of the default network gateway for all traf
fic beyond the
local network.
Start IP Enter the start IP address of the range that the DHCP server can assign.
End IP Enter the end IP address of the range that the DHCP server can assign.
Use Default DNS Server Select this check box to allow the DHCP server to use the wireless controller’
s
default DNS servers.
The Primary DNS Server and Secondary DNS Server fields are masked out.
Primary DNS Server Enter the IP address of the primary DNS server for the network.