Quick Reference Guide

Configure Wireless and QoS Settings
145
ProSAFE Wireless Controller WC9500
The Advanced QoS Settings screen lets you modify the QoS settings per profile group
and per radio for upstream traffic flowing from the station (that is, the wireless client) to
managed access points and the downstream traffic flowing from managed access points
to the station. These settings are applied only to managed access points that are capable
of supporting these settings.
Disabling WMM deactivates QoS control of station EDCA parameters for upstream traffic
flowing from the client station to the access point. (Y
ou can change the settings for the
station EDCA parameters, but these settings do not take effect until you enable WMM.)
However
, when WMM is disabled, you can still set some parameters for downstream
traffic flowing from the access point to the client station (AP EDCA parameters), and
these settings do take effect even when WMM is disabled.
 To configure the QoS settings for a profile group:
1. Select Configuration > Wireless > Advanced > QoS.
The
Advanced QoS Settings screen displays:
2. Click the tab for the profile group for which you want to configure the QoS settings.
3. Click the tab for the radio for which you want to configure the QoS settings.
4. Configure the settings as described in the following table: