Quick Reference Guide

Configure Wireless and QoS Settings
141
ProSAFE Wireless Controller WC9500
RF Management for the Basic Profile Group
The basic RF Management screen lets you configure the wireless transmission power,
WLAN healing, and wireless coverage hole detection for the basic profile group.
 To configure RF management for access points in the basic profile group:
1. Select Configuration > Wireless > Basic > RF Management.
The basic RF Management screen displays:
2. Configure the settings as described in the following table:
Setting Description
TX Power Settings
Default Tx Power Make a selection from the menu to specify how the transmission (Tx)
power is configured on the access points: Full, Half, Quarter, Eighth,
or Minimum.
When automatic Tx power control is enabled, the selection from the
menu is used as the initial power level for the access points.
Automatic Tx Power Control Select the enable radio button to enable automatic
Tx power control:
• When a client attempts to connect to an access point at low power
,
the access point’s Tx power is automatically increased above the
default level.
•
When there are overlapping coverage areas, the access point’s Tx
power is automatically decreased below default level.
Select the disable radio button to disable automatic
Tx power control.