Quick Reference Guide

Discover and Manage Access Points
105
ProSAFE Wireless Controller WC9500
 To view the WLAN Group Assignment screen:
Select Configuration > WLAN Network.
The settings are explained in the following table:
Setting Description
IP The IP address of the access point.
MAC The MAC address of the access point.
Model The model of the access point.
Name The name that you specified for the access point.
Building The building designation is always Building-1.
Floor The floor designation is always Floor-1.
Status • Authentication in progress. This
status can
last several minutes.
• Applying configurations.
• Firmware upgrade.
• AP is rebooting.
• Connecting. Make sure that there is a DHCP server enabled in the network;
otherwise, the managed access points remain in the Connecting state and do
not enter the Connected state.
• Connected. This
status indicates
normal operation.
• Not Connected. The wireless controller cannot communicate with the access
point at the configured IP address. The wireless controller tries to log in to
managed access points each minute. If the error is temporary
, the status
automatically changes to Connected. If the error is prolonged, verify the access
point’s IP address and network connectivity. For more information, see Problems
with Access Points on page 202.
Remote The site designation is always Local.
Group Name The profile group to which the access point is assigned.
For information about creating profile groups and their associated security profiles,
see Configure Security Profiles for Advanced Profile Groups on page 71.