User Manual

Table Of Contents
Configure WiFi, Radio Frequency, and QoS Settings
193
Wireless Controller
Configure Automatic Transmission Power
By default, automatic transmission (Tx) power control is enabled and the initial power
transmission level for an access point is half of its capacity. Power is automatically adjusted
in the follows ways:
When a client attempts to connect to an access point at low power, the access point’s
Tx
power is automatically increased above the default level.
When coverage areas overlap, the access point’s Tx power is automatically decreased
below default level.
Y
ou can change the initial power transmission level. Other options are full, quarter, eighth, or
minimum initial power level.
Configure Automatic Transmission Power for the Basic Profile
Group
By default, automatic Tx power control is enabled for access points in the basic profile group.
You can adjust the settings or disable automatic Tx power control.
To configure automatic transmission power for access points in the basic profile
group:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > RF Management > Basic >
Auto Tx Power.