User Manual

Discover and Manage Access Points
171
Wireless Controller
Change Access Point Information on the Managed AP List
For each individual access point, you can change the general information, IP settings, and
VLAN settings, you can switch between the internal and external antenna (if the access point
supports an external antenna), and you can enter location information.
For a WAC740 access point that is on the managed list, you can also enable link aggregation
by using the following procedure. Link aggregation is required if you want to set up a link
aggregation group (LAG) connection between the WAC740 access point and a switch.
For more information about setting up a LAG connection for a W
AC740 access point, see
Enable Link Aggregation on a WAC740 Access Point on page 388.
Note: Do not confuse link aggregation for a WAC740 access point with link
aggregation for a WC7600v1 or WC9500 wireless controller (see
Controller Link Aggregation Concepts on page 104), which is a
configuration between the WC7600v1 or WC9500 wireless controller
and a switch or router.
 To change the information for an access point on the Managed AP List:
1. Open a web browser, and in the browser
’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and Change Access Point Information on the Managed AP List on
page 171.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Access Point > Managed
AP List
.
The Managed AP List page displays.
5. Select the access point that you want to change by selecting its radio button in the Edit
column of the Managed AP List.
6. Click the Edit button.