Configuring Guest Access on separate VLAN

Page 15

Step 4 - Discover and add your AP

Select Access Point – Discovery Wizard. Choose Factory Default state and Same L2 network. You should ﬁ nd the Access

Point on its default IP address. Select it, and select Add. Leave the password ﬁ eld blank and select Add. Wait until you see

Connected in the status column. This will take a few minutes

Router

Step 1 – Add static routes to new Wireless LANs

The router needs to know about these new IP subnets. So we need to add two static routes. One for

192.168.10.0/255.255.255.0 and on for 192.168.20.0/255.255.255.0, through the gateway, which is the switch on

192.168.1.2.

NOTES

This guide is based on a factory default WC7520, running ﬁ rmware 2.5.0.5_3215.

NETGEAR, the NETGEAR logo, ProSAFE and ProSECURE are trademarks and/or registered trademarks of NETGEAR, Inc. and/or its subsidiaries in the United