User Manual

3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
If you previously managed the AirBridge through the NETGEAR Insight app or Insight
Cloud portal, enter the Insight network password for the Insight network location to
which the AirBridge was assigned (see Connect over WiFi using the NETGEAR Insight
app on an iOS or Android mobile device on page 15).
The Device Status page displays the Device Information section and other sections.
4. Under Network, select Wireless.
The Wireless Settings page displays.
5.
Click the Bit Rate Configuration button.
A new page opens.
6. Write down the current bit rate.
After you change the bit rate, if WiFi devices can no longer connect to the AirBridge,
you can reset the bit rate to the old value.
7. On the blue bar, select a new bit rate by clicking the white dot that represents the
bit rate.
The bit rate is expressed in Mbps.
8. Click the Save button.
Your settings are saved but not yet applied. The page closes. The Wireless Settings
page displays again.
A pop-up window opens. The window shows the number of changes to be applied.
9. In the pop-up window, click the Apply button.
Your changes are applied. If the WiFi link must be reestablished, the page displays
the number of seconds before the AirBridge is back online.
Manage client limits
If the AirBridge functions as a master with the AirBridge mode disabled or as an access
point, by default, a maximum of 32 WiFi client can associate with the AirBridge.
You can specify a lower or higher number of maximum WiFi clients. The range is from
1 to 32. The maximum number applies to all clients connected to all 5 GHz SSIDs on
the AirBridge. You cannot set client limits for individual 5 GHz SSIDs.
User Manual96Manage Advanced WiFi and
Radio Features
Insight Instant AirBridge WBC502 User Manual