Installation Guide

Installation options
Access Point Model WAX610
Mounting bracket with screw holes for
mounting to a solid ceiling or 15/16in.
(23.8mm) T-bar.
Package contents
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
© NETGEAR, Inc., NETGEAR and the NETGEAR
Logo are trademarks of NETGEAR, Inc. Any
non-NETGEAR trademarks are used for reference
purposes only.
May 2020
NETGEAR INTERNATIONAL LTD
Floor 1, Building 3,
University Technology Centre
Curraheen Road, Cork,
T12EF21, Ireland
Insight Managed
WiFi 6 AX1800
Dual Band Access Point
Model WAX610
Installation Guide
2. Line up the holes on the bottom of the
access point with the screws in the wall
and mount the access point to the wall.
Mount to a solid ceiling
Mount to a solid wall
1. Mark the wall where you want to insert
the provided anchors and screws, which
must be 3.875 in. (98.5 mm) apart, and
insert the anchors and screws.
Leave about 0.25 in. (6 mm) of each
screw protruding from the wall so that
you can insert the screws into the holes
on the bottom of the access point.
Two screws and anchors for ceiling- or
wallmounting
Note: Depending on the product ordered,
the package might not include a power
adapter. You power up the access point by
connecting it to a PoE+ switch. However, as an
option, you can order a power adapter.
3.875 in. (98.5 mm)
1. Using the anchors and screws provided,
attach the 15/16 in. (23.8mm) bracket
with the screw holes to the ceiling.
The rectangular protruding part of the
bracket must be facing the ceiling.
2. Hold the access point upside down with
the front of the access point facing the
bracket. Then, line up the guides on
the bottom of the access point with the
bracket.
3. Slide the access point into the bracket
until it locks in place. The locking tab
must be at the front of the access point.
The bottom of the access point includes two
holes that let you mount the access point on
two screws inserted in a wall.
Note: To unlock the access point, push the
locking tab toward the ceiling and slide the
access point out of the bracket.
Locking tabSide view
Mounting bracket without screw holes for
mounting to a 9/16 in. (14.3 mm) T-bar.
Mount to a T-bar
1. Depending on the size of the T-bar,
slide the 9/16 in. (14.3 mm) or 15/16in.
(23.8mm) bracket between the guides
on the bottom the access point until it
locks in place. The locking tab must be at
the front of the access point.
2. Hold the access point upside down.
Note: If you can reach behind the T-bar,
hold the T-bar with one hand and the
access point with your other hand.
3. Align the rectangular protruding part of
the bracket with the T-bar.
4. Hook the bracket onto one side of the
T-bar.
5. Hook the bracket onto the other side of
the T-bar until the bracket locks onto the
T-bar.
You can mount the access point to a solid
surface (a wall or a ceiling) or to a ceiling with
a 9/16 in. (14.3 mm) or 15/16 in. (23.8mm)
T-bar, or you can install the access point
freestanding on a at surface.
We recommend that you use a at Ethernet
cable so that the cable ts in the narrow
space between the access point and the
surface on which it is mounted or placed.