User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
202-10078-01
viii Contents
802.11a Configuration ......................................................................................3-20
802.11b/g Configuration ...................................................................................3-21
How to Set Up and Test Basic Wireless Connectivity ............................................3-22
How to Restrict Wireless Access by MAC Address ...............................................3-23
How to Configure WEP ..........................................................................................3-24
How to Configure WPA with Radius .......................................................................3-26
How to Configure WPA-PSK ..................................................................................3-29
Using the Basic IP Settings Options .............................................................................3-30
Chapter 4
Management
Remote Management .....................................................................................................4-1
Using the Secure Telnet Interface ..................................................................................4-2
How to Use the CLI via the Console Port .................................................................4-2
CLI Commands ........................................................................................................4-3
Using Syslog and Activity Log Information .....................................................................4-4
Viewing General and Statistical Information ...................................................................4-5
General Information .................................................................................................4-5
Statistics ...................................................................................................................4-8
Viewing a List of Attached Devices .................................................................................4-9
Upgrading the Wireless Access Point Software ...........................................................4-10
Configuration File Management ...................................................................................4-10
Saving and Retrieving the Configuration ................................................................4-11
Restoring the WAG302 to the Factory Default Settings ......................................... 4-11
Using the Reset Button to Restore Factory Default Settings .................................4-12
Rebooting the Access Point ...................................................................................4-12
Changing the Administrator Password .........................................................................4-13
Chapter 5
Advanced Configuration
Understanding Advanced IP Settings for Wireless Clients .............................................5-1
Understanding Advanced Wireless Settings ..................................................................5-3
AutoCell RF Management ........................................................................................5-4
Configuration .....................................................................................................5-5
AutoCell AP/Client Interaction ...........................................................................5-6
Additional AutoCell View Management Options ................................................5-7
Configuring Wireless LAN Parameters ....................................................................5-8










