User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Advanced Configuration 5-9
202-10078-01
Enabling Wireless Bridging and Repeating
The WAG302 ProSafe Dual Band Wireless Access Point lets you build large bridged wireless
networks.
Figure 5-6: Advanced Wireless Settings Access Point Mode settings (11a and 11b/g)
Select the desired Access Point mode for your environment:
• Wireless Point-to-Point Bridge: In this mode, the WAG302 will communicate ONLY with
another Bridge-mode Wireless Station. You must enter the MAC address (physical address) of
the other Bridge-mode Wireless Station in the field provided. WEP can (and should) be used to
protect this communication.
Advanced Access Point Settings 11a menu Advanced Access Point Settings 11b/g menu