User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Advanced Configuration 5-3
202-10078-01
– Subnet Mask: The Access Point will assign the specified subnet mask to the connected
wireless stations.
– Gateway Address: The Access Point will assign this IP address as the default gateway for
any traffic beyond the local network.
– Primary DNS Server: The Access Point will assign this IP address as the primary
Domain Name Server used by the connected wireless stations.
– Secondary DNS Server: The Access Point will assign this IP address as the secondary
Domain Name Server used by the connected wireless stations.
– Primary WINS Server: The Access Point will assign this IP address as the primary
WINS Server used by the connected wireless stations.
– Secondary WINS Server: The Access Point will assign this IP address as the secondary
WINS Server used by the connected wireless stations.
– Lease: The lease time for the IP address assigned. The wireless client user is required to
renew the IP address as soon as the lease is expired.
Understanding Advanced Wireless Settings
The advanced wireless settings menus enable configuration of the following:
• AutoCell RF management
• Advanced wireless parameters
These options are discussed below.