User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
5-2 Advanced Configuration
202-10078-01
Figure 5-1: Advanced IP Settings for Wireless Clients screen
You may configure the Advanced IP Settings for Wireless Clients if you are a network system
administrator.
• Use AP as DHCP Server: You may turn on this option and the Access Point will function as a
DHCP Server for Wireless Clients only. The Access Point will provide the pre-configured
TCP/IP configurations for all wireless stations connected to this Access Point.
There are two options available for managing the wireless clients:
– Accept DHCP Enabled Wireless Clients Only: The Access Point can only provide the
TCP/IP configurations to those wireless clients with the DHCP enabled.
– Accept Both DHCP Enabled and Static IP Configured Wireless Clients: The Access
Point will support wireless clients with the DHCP enabled and the static IP configured.
You need to configure the following TCP/IP configurations for using Access Point as a DHCP
Server for Wireless Clients.
– Starting IP Address: Type the starting IP address can be assigned from the DHCP server
on this Access Point.
– Ending IP Address: Type the Ending IP address can be assigned from the DHCP server
on this Access Point