User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Advanced Configuration 5-1
202-10078-01
Chapter 5
Advanced Configuration
This chapter describes how to configure the advanced features of your WAG302 ProSafe Dual
Band Wireless Access Point:
• IP Settings: Use the AP as a DHCP server for wireless clients.
• Wireless Settings: Set up AutoCell and configure advanced wireless LAN parameters.
• Access Point Settings: Enable wireless bridging and repeating.
These features can be found under the Advanced heading in the main menu.
Understanding Advanced IP Settings for Wireless Clients
The default advanced IP wireless settings usually work well. If you want the AP to act as a DHCP
server gateway for wireless clients, use this feature. The AP accepts both static and DHCP clients.