User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
4-8 Management
202-10078-01
Statistics
The Information - Statistics screen provides various LAN and WLAN statistics.
Figure 4-5: Wireless Access Point Status screen
Table 4-1. Statistics Fields
Field Description
Wired Ethernet Received/Transmitted
Packets The number of packets sent since the WAG302 was restarted.
Bytes
The number of bytes sent since the WAG302 was restarted.
Wireless 11a Received/Transmitted
Unicast Packets The Unicast packets sent since the WAG302 was restarted.
Broadcast Packets The Broadcast packets sent since the WAG302 was restarted.
Multicast Packets The Multicast packets sent since the WAG302 was restarted.
Total Packets The Wireless packets sent since the WAG302 was restarted.
Total Bytes The Wireless bytes sent since the WAG302 was restarted.