User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Management 4-7
202-10078-01
Current Wireless Settings 11b/g
Access Point Mode Identifies the operating mode of the WAG302: Access Point, Point-to-point
bridge, Multi-point bridge or Repeater.
Operating Mode Identifies the 802.11 operating mode of the WAG302.
Wireless Network Name
(SSID)
Displays the wireless network name (SSID) being used by the wireless port
of the wireless access point. The default is NETGEAR_11g.
Channel/Frequency Identifies the channel the wireless port is using. 11 is the default channel
setting. See “Wireless Channels” on page B-7 for the frequencies used
on each channel.
WEP/WPA WEP/WPA setting.
Table 4-1. General Information Fields
Field Description