User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
4-4 Management
202-10078-01
Using Syslog and Activity Log Information
The Information contains the activity log link you can use for setting up a syslog server and
viewing activity log information. From the main menu of the browser interface, under the
Information heading, click the Station List link to view the list, shown below.
Figure 4-3: Syslog and Activity Log information
Enable the SysLog option if you have a SysLog server on your LAN. If enabled, you must enter
the IP address of your SysLog server and the port number your SysLog server is configured to use.
• SysLog Server IP address: The access point will send all the SysLog to the specified IP
address if SysLog option is enabled. Default: 0.0.0.0
• Port: The port number configured in the SysLog server on your LAN. Default: 514
The Activity Log Window displays the Access Point system activity.
You may click Refresh to update the display or Click Save As. To save the log contents into a file
on your PC, click Save As and save the file to a disk drive.