User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Management 4-1
202-10078-01
Chapter 4
Management
This chapter describes how to use the management features of your WAG302 ProSafe Dual Band
Wireless Access Point. These features can be found by clicking on the Maintenance heading in the
Main Menu of the browser interface.
Remote Management
The Remote Management screen lets you enable remote console and specify the simple network
management protocol (SNMP) parameters.
Figure 4-1: Remote Management screen
Fill out the remote management information:
• Remote Console
Secure Shell (SSH): If set to Enable, the Wireless Access Point will only allow remote access
via Secure Shell and Secure Telnet (see “Using the Secure Telnet Interface” on page 4-2). The
default is Enable.