User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Basic Installation and Configuration 3-31
202-10078-01
If your network has a requirement to use a different IP addressing scheme, you can make those
changes in this menu. These settings are only required if the “Use this IP address” radio button
is chosen. Remember to click Apply to save your changes.
• Spanning Tree Protocol
Spanning Tree Protocol in enabled by default for the wireless access point. This provides
network traffic optimization in settings with multiple WAG302 Access Points.
•Time Zone
Select the time zone location for your setting.
Note: You must have an Internet connection to get the current time.