User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
Basic Installation and Configuration 3-29
202-10078-01
How to Configure WPA-PSK
Note: Not all wireless adapters support WPA. Furthermore, client software is required on the
client. Windows XP and Windows 2000 with Service Pack 3 or above do include the client
software that supports WPA. Nevertheless, the wireless adapter hardware and driver must also
support WPA. Consult the product document for your wireless adapter and WPA client software
for instructions on configuring WPA settings.
To configure WPA-PSK, follow these steps:
1. Log in at the default LAN address of http://192.168.0.230 with the default user name of
admin and default password of password, or using whatever LAN address and password you
have set up.
2. Click the WEP/WPA Settings link in the main menu of the WAG302.
Figure 3-15: WEP/WPA Settings menus for 11a and 11bg
3.
Choose WPA-PSK from the list.
4. Enter the pre-shared key passphrase.
5. Click Apply to save your settings.
WEP/WPA Settings 11a menu WEP/WPA Settings 11b/g menu