User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
3-28 Basic Installation and Configuration
202-10078-01
• IP Address: The IP address of the Radius Server. The default is 0.0.0.0
• Port Number: Port number of the Radius Server. The default is 1813.
• Shared Secret: This is shared between the Wireless Access Point and the Radius Server
while authenticating the supplicant.
5. Click Apply to save your settings.
6. Click WEP/WPA Settings in the Security menu.
Figure 3-14: WEP/WPA Settings menus for 11a and 11bg
7.
Choose WPA with Radius from the list.
8. Click Apply to save your settings.
WEP/WPA Settings 11a menu WEP/WPA Settings 11b/g menu