User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
3-24 Basic Installation and Configuration
202-10078-01
3.
The optional Access Control window lets you block the network access privilege of the
specified stations through the WAG302 Access Point. When you enable access control, the
access point only accepts connections from clients on the selected access control list. This
provides an additional layer of security.
a. Choose the Turn Access Control On to enable Access Control feature.
b. Select the desired Access Control Database options. The options are:
• Local MAC Address Database – The Access Point will use the local MAC address
table for Access Control. This is the default.
• RADIUS MAC Address Database – The Access Point will use the MAC address table
located on the external Radius server on the LAN for Access Control.
c. Trusted Wireless Stations: This lists any wireless stations you have entered. If you have
not entered any wireless stations this list will be empty. To delete an existing entry, select
it and then click the "Delete" button.
d. Available Wireless Stations: Select the stations from the wireless station list and click
Add button to add to the Trusted Wireless Stations list.
e. Add new Station Manually: Use this to add the MAC address of the wireless stations to
the Trusted Wireless Stations list.
Now, only devices on this list will be allowed to wirelessly connect to the WAG302.
How to Configure WEP
To configure WEP data encryption, follow these steps:
1. Log in to the WAG302 using its default address of http://192.168.0.230 or at whatever IP
address the unit is currently configured Use the default user name of admin and default
password of password, or whatever LAN address and password you have set up.