User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
3-12 Basic Installation and Configuration
202-10078-01
How to Log In to the WAG302 Using Its Default IP Address
1. 192.168.0.230 is the default IP address of your access point. The WAG302 is set by default
with the DHCP client disabled.
Note: The computer you are using to connect to the WAG302 should be configured with an IP
address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.
2. Open a Web browser such as Internet Explorer or Netscape Navigator.
3. Connect to the WAG302 by entering its default address of http://192.168.0.230 into your
browser. A login window appears.
Enter admin for the user name and password for the password, both in lower case
letters.Click Login now.
Figure 3-7: Login window
Once you have entered your access point name, your Web browser should automatically find
the WAG302 Access Point and display the home page, as shown in “Login result: WAG302
General information page” on page 3-7.