User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
3-10 Basic Installation and Configuration
202-10078-01
b.
Click the Wireless Settings11a link in the Setup section of the main menu to view the
Wireless Settings 11a menu.
Figure 3-5: Wireless Settings 11a menu
c.
Click the Wireless Settings 11b/g link in the Setup section of the main menu to view the
Wireless Settings 11b/g menu.
Figure 3-6: Wireless Settings 11b/g menu
d.
Configure the wireless interface for wireless access. See the online help or the
Understanding Basic Wireless Settings topic of this Reference Manual for full
instructions.
Note: You must set the Regulatory Domain. It may not be legal to operate the wireless
access point in a region other than one of those identified in this field.