User's Manual
Table Of Contents
- Technical Support
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Antenna Statement for North America and Australia
- Industry Canada Compliance Statement
- Product and Publication Details
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WAG302 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Command Line Reference
- Glossary
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
3-8 Basic Installation and Configuration
202-10078-01
• Click the Basic Settings link to view the Basic Settings menu.
Figure 3-4: Basic Settings menu
• Configure the settings appropriate for your network. The default values are suitable
for most users and situations.
– Access Point Name: This unique name is the access point NetBIOS name. The
default Access Point Name is located on the bottom label of WAG302. You may
modify the default name with a unique name up to 15 characters long. The default
is netgearxxxxxx, where xxxxxxx represents the last 6 digits of the WAG302
MAC address.